Probably my biggest question is whether it will do more than the. posted by Hypertherm, it is just the machine I am looking for, but I have not found anything to back that up. I have scoured the internet for information, and found lots of good things, but very little with the machine being used on a CNC table. I do thank every one for their advice, and this post was just a desperate attempt at finding someone who knew where I could get some more detailed technical specs than in my manual since the dealer, and Google have not turned up anything useful.Īs for the PowerMax. I have tested almost every component on the board while sitting on my rear watching TV so I am fairly certain if I replace these few components there will not be a repeat of the burnt outs. ![]() The board went up in smoke due to a foreign piece of steel that wound up in the unit from a bonehead move I am too embarrased to admit. One the other hand three are complete toast, and there is no physical way to figure them out. ![]() Two resistors, and one diode are faulty, but not burnt to the point that I cannot identify them.
0 Comments
Leave a Reply. |